
Electric floor heating Adelaide
Under-tile and in-slab heating for Adelaide homes, supplied and installed across Adelaide and regional South Australia. ELEKTRA cable with a 20-year warranty.
Cold winter floors, from renovations to new builds.
Adelaide winters are cool and damp, and many homes have slab, tile or stone floors. Renovations and new builds share the same problem: the floor stays cold while the air above it warms.
Electric floor heating warms the floor itself, room by room, with each room on its own thermostat. Nothing hangs on the walls and nothing blows air around.
P.A.P. Heating Solutions has supplied floor heating since 1988 and is the exclusive Australian importer of ELEKTRA heating cable. We supply and install across Adelaide and regional South Australia.

Two systems for Adelaide homes.
Renovations mostly go under the tiles. New builds and rear extensions can have the cable in the slab. The layout shows the right system for each room.

Under-tile heating
ELEKTRA DM20 sits in the tile adhesive bed, 20 W per lineal metre. It suits bathroom renovations and retiled living areas on an existing slab.
Under-tile heating
In-screed heating
ELEKTRA DM20 can also go in a screed over an existing slab, under timber, tile or polished finishes. It suits renovations where floors are being replaced.
In-screed heatingFrom plans to a warm floor.
Upload plans or sketch the rooms with sizes. A rough hand drawing is fine for a single bathroom.
Within 24 hours you get a cable layout, the load requirements for your electrician and a list of parts.
We supply the cable, thermostats and parts, or we install it for you. A licensed electrician makes the final connection.
The cable is tested before and after the floor goes down. You set each room on its own thermostat.
What we see in Adelaide.
Renovations
Older homes are often renovated room by room. Bathrooms, kitchens and new rear extensions are where floor heating usually goes in.
Brick homes on slab
Much of suburban Adelaide is brick on slab with tiled wet areas. Under-tile cable goes straight onto the existing slab when the bathroom is retiled.
New builds and extensions
In-slab heating suits new homes and extensions. Plan it with your builder before the pour.
Adelaide and regional South Australia.
We supply and install Australia-wide. Supply only is available for your own tiler and electrician.
Floor heating in Adelaide, answered.
Do you install floor heating in Adelaide?
Yes. We supply and install across Adelaide and regional South Australia, or supply cable and parts to your own trades. The layout is free.
Can floor heating go into an older home?
Yes. Bathrooms go under the tiles. Living areas with new floors can have cable in a screed. The layout notes what each floor needs.
Which system suits a new build?
In-slab heating with ELEKTRA VCD35, tied to the reo before the pour. Send plans early so it is drawn with the slab.
How long does a layout take?
Send your plans and you will receive the layout, load requirements and parts list within 24 hours, at no cost.
What does it cost to run?
It depends on room size, insulation and your tariff. The running cost calculator gives a figure for your rooms.
Do I need an electrician?
Yes. A licensed electrician makes the final connection. We give them the load requirements with the layout.
Send your plans. Free layout within 24 hours.
Adelaide plans can be emailed to us. We provide the layout design and load requirements at no cost. Email info@papheatingsolutions.com.au or call (02) 6242 9310.